Everyone in his life at least once asked this question how to make a crate for the floor himself.
For a warm wooden floor, you can make a concrete base, filling a concrete screed and leaving the surface with pendulums. Do not rush to laying boards. Follow the clearly outlined work plan. A special crate with thermal insulation is extremely not disgraced in this case. Materials and tools that are used in the work to create a crate: waterproofing gasket, wooden scraps for wedges, screws, dowels, alcohol level, powerful drill, wooden rivers.
The installation process is not complicated, everyone can cope with it. It is necessary to install a heat -insulating plate on top of a pre -prepared concrete base. Then lay the waterproofing gasket directly on the concrete. It should exceed the size of the floor.
So that then there are no problems with waterproofing, we take into account turns to the walls. The floor thickness above the laying should be less than the height of each lapel. In order to wrap the film on the wall, you need to cut the corners. We do this for convenience in work. Lay along the walls of the cutting rail. She acts as a support for the rest of the rails. In wood, through the concrete floor, the hole drills, and fix the rail with fasteners, not forgetting to use the dowels. We drive it into a pre -drilled hole with a hammer, screwed, as it should, tighten the fasteners.
In the same way, we fix all the remaining rails throughout the territory of this room. Cross rails are laid between them, the interval should be 50 cm. We take the alcohol level and check if the rails are at the same height. If the height of the rails does not coincide relative to each other, then we align the height by inserting the wedges under the rails. If this is not done, then there will be a slope and curvature. Directly through the wood, we fit the rails to the concrete.
Between the rails we lay thermal insulation slabs. They can be from any composite non -combustible materials, the main thing is to maintain heat well without missing cold air. Drilling or trimming boards, the so -called plank coating, lay on top of the crate. The coating material is also very diverse, selected for your taste and needs. So we made a crate for our gender. Work, as you can see not complicated, everyone can cope with it without resorting to the help of specialists.