Two doors and one front part of the drawer can be cut out of one sheet of material. Before cutting the doors, make the transverse marking for the front part of the drawer. The calculation of the width of the door, if you use hidden euro loops, is simple.
First you need to measure the inner width of the cabinet, add 25 mm (1 inch) to this value and divide by two. It will be the width of the door. My doors and the front part of the drawer are made of chipboard 18 mm thick. Cut two doors and one front of a drawer. Before installation, stick the end tape on all open edges.
To install the doors, use three hidden euros loops with a course of 107 ° for each door. The lower edge of the front of the drawer is at the same level with the lower bottom of the bottom. It is attached with four screws 25 mm long (1 inches), which was traveled through the box. Leave the gap 13 mm between the upper edge of the front part and the lower edge of the door.