Plasterboard ceilings continue to be popular with consumers. But it is not so easy to install. All actions are performed independently in the presence of the necessary knowledge, tools.
From the very beginning you need to mark the design location of your suspended ceiling. This is performed around the perimeter of the room, on the walls including. For this purpose, use a level with a length of more than 1.5m. The cord with the hydraulic level will also be useful. Marking is applied according to the project.
We get to work
Next, you should make markings of the fastening points of all suspensions. A perforator in places of such markings must be drilled holes. Their diameter should be 6mm, depth — 60mm. If the base is wooden, then use self -tapping screws with large threads for fastening the parts of the frame. No need to do preliminary drilling. In this suspension system, a direct suspension is used to attach the profile directly to the supporting structure. If there are changes in the level of the structure, then you must additionally use the suspension designed for PP profiles. To fasten such profiles, it is initially necessary to set the craving. Drill the hole in the supporting structure. Anchlin-clin should be inserted into the thrust eye. The latter is clogged into a drilled hole with a hammer.
Then you can start installing a straight suspension. Its fastening is carried out using the same anchor clin. It is inserted into the suspension plate, clogged into the previously made hole. Then bent all the side stripes of your straight suspension, holding the angle of 90 degrees.
Then you can install PP profiles (wooden bars). You should check their horizontal location using the level. Publish from the markings applied on the wall. The length of the main profile, as a rule, is less than the length of the room by 10mm.
Go further to the installation of drywall. In the design, place the wiring. Remember safety precautions. A drywall sheet is inserted into a design position, fixed to the frame. Such sheets should only be placed horizontally. They are attached to the frame with screws.